Digital Input Assignment - Pioneer VSX-D709S Operating Instructions Manual

Quick Start Guide
3 3 3 3 3 Setting up the Remote Control & Unit
1 Put the batteries in the Remote Control.
2 Plug the main unit into a AC wall outlet.
3 Press the

4 4 4 4 4 Digital Input Assignment

This is only necessary if you hooked up your DVD to DIGITAL IN 3, as in the first diagram on p. 5 (an
optical digital connection).
2
1
3-9
1 Press the RECEIVER.
This switches the remote to the surround setup
mode.
2 Press the SYSTEM SETUP button.
You should see the following display on your
receiver.
• You can escape from this screen at any time
by pressing the SYSTEM SETUP button
again. None of the settings you made will be
entered in this case.
• If don't enter any settings the receiver will
revert back to its previous state after three
minutes.
3 "Assign Set" should be selected (if it
isn't use the 5¥∞ buttons to select
it). Press ENTER.
You should see the following display on your
receiver.
6
STANDBY/ON button on the receiver to put the receiver in ON mode.
SOURCE RECEIVER
VCR VCR
DVD TV
1 2
MULTI CONTROL
CD CD-R TUN TVC
1 2 3
LOUDNESS VIDEO SELECT MULTI CH INPUT
4 5 6
INPUT ATT DIGITAL NR FL DIMMER
7 8 9
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10
DISC
0
ENTER
EFFECT/CH SEL
RECEIVER
TV VOL TV MASTER VOLUME
TV CONTROL
TVFUNK
4 ¢
CHANNEL
TUNE
ST ST
ENTER
TUNE
GUIDE MENU
D.ACCESS BAND CLASS
& ‹ *
4 "Digital in" should be selected (if it
isn't use the 5¥∞ buttons to select
it). Press ENTER.
You should see the following display on your
receiver.
5 Choose the "Digital-3" with 5¥∞
buttons you hooked up your DVD
player to. Press ENTER.
6 Choose the "DVD/LD" (if it isn't use
the 5¥∞ buttons to select it). Press
ENTER.
7 Select "Dig-In End" with 5¥∞
buttons and press ENTER to return
to the Dig-In Setup menu.
8 Select "Assign End" with 5¥∞
buttons and press ENTER to return
to the Assign Setup menu.
9 Select "Setup End" with 5¥∞
buttons and press ENTER to return
to the System Setup menu.