Pioneer VSX-D709S Operating Instructions Manual page 35

SOURCE RECEIVER
VCR
DVD TV
1
MULTI CONTROL
CD CD-R TUN
1 2
LOUDNESS VIDEO SELECT MULTI CH INPUT
4 5
INPUT ATT DIGITAL NR FL DIMMER
7 8
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10
0
ENTER
EFFECT/CH SEL
RECEIVER
TV
TV VOL MASTER VOLUME
TV CONTROL
TVFUNK
4
CHANNEL
TUNE
4-6
ST
ENTER
TUNE
GUIDE MENU
D.ACCESS BAND
& ‹
MPX DTV ON / OFF DTV MENU
¶ !
RETURN S.MODE CLEAR DTV INFO
RECEIVER DIRECT CONTROL
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
2
/ DTS
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
memo
Note that it is also possible to set
channel levels temporarily. Then follow
the same procedure as explained on
this page. This function is designed to
be used when you want to change the
levels temporarily to raise the level of
one channel. Using this method you
can set speaker levels in different
modes, such as, STEREO, and each
DSP mode, independently. You should
return the settings to their original
state when done. Doing the set up
procedures on this page will erase any
temporary/independent level settings
that have been made.
4 Adjust speaker levels so that you hear the
test tone at the same volume from each
speaker when seated in your main listening
position.
Note: The volume of the subwoofer tends to sound lower than
VCR
2 it actually is, you may need to raise its level after testing the
TVC
sound with actual soundtracks.
3
In AUTO mode
6
The receiver will automatically cycle through the speakers
9
emitting a test tone from each one. It will continue to do this
DISC
until you press ENTER to signify you have finished your adjust-
ments.
In MANUAL mode
¢
1 Press ENTER
2 Press the 5/∞ buttons (or the MULTI JOG dial) to adjust the
ST
level of the speaker outputting the TEST TONE.
3 Press ENTER again to input the information and move to the
CLASS
*
next channel.
⁄
4 Repeat 1, 2 and 3 for each speaker.
RDM
If you are using a Sound Pressure Level (SPL) meter
Take the readings from your main listening position and adjust
the level of each speaker to 75 dB SPL (C-weighted/slow
Î
mode).
5 When you have adjusted each speaker level
and entered the information "Ch Level End"
will be selected. Press ENTER .
It will again take a moment as the MASTER VOLUME returns
to its original position.
6 Press ENTER again to return to go to the
"Crossover" settings.
Next, proceed to Crossover Network on the next page.
If you want to change a setting before proceeding
use the 5/∞ buttons (or the MULTI JOG dial) to go back.
Initial Set Up
35