Placing Your Speakers - Pioneer Elite VSX-35TX Operating Instructions Manual

Connecting Your Equipment
Speaker impedance
You can change the speaker impedance for VSX-35TX but we recommend using speakers with an impedance of
8 -16 (the default setting). If you are using 6 - less than 8 impedance speakers, you need to change the
impedance setting. Use any speaker rated between 6 -16 .
STANDBY/ON
SPEAKERS
memo
To check which impedance setting to
hold down the SPEAKERS button for
2-3 seconds. You'll get a display like
these telling you the speaker
impedance setting.

Placing Your Speakers

Proper speaker placement is essential to realize the best sound from your system. The diagram and tips given
here are just a rough guide; be sure to read the instructions that come with your speakers.
Speaker placement
If you have a multiple speaker arrangement the placement of the speakers is extremely important. To achieve the best
possible surround sound, install your speakers as shown below. Make sure all speakers are installed securely to prevent
accidents and improve sound quality. Be sure to consult your speaker manuals for the best placement of the speakers. Some
speakers are designed to be floor-standing but others benefit greatly from speakers stands which raise them off the floor.
memo
• Install the left and right front speakers at equal distances from the TV.
• When installing speakers near the TV, we recommend using magnetically shielded speakers to prevent
possible interference such as distortion in the color of the TV screen. If you do not have magnetically
shielded speakers and notice discoloration of the TV screen, place the speakers farther away from the TV.
• Install the center speaker above or below the TV so that the sound of the center channel is localized at
the TV screen.
CAUTION:
When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker
may fall from the TV due to external shocks such as earthquakes, and it may lead to endangering those nearby or damaging the speaker .
• If possible, install the surround speakers slightly above ear level.
• It may be difficult to obtain a cohesive surround effect if the surround speakers are installed farther
away from the listening position than the front and center speakers.
20
First put the receiver in STANDBY mode, then press the power
button while holding down the SPEAKERS button.
The receiver will re-set to the new impedance setting. You can
choose the 8 -16 setting or the 6 -8 setting.
(This display indicates a 6 -
less than 8 impedance
setting.)
(This display indicates an 8 -
16 impedance setting.)
Front Front
Left Center Right
Sub
Woofer
Surround Surround
Listening
Left Right
Position
Surround Back Surround Back
Left Right