Onkyo TX-SR504S Instruction Manual page 35

First Time Setup—Continued
5
Use the Down [
select "Center," and then use the
Left and Right [
select Small, Large, or None.
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
large.
None: Select if no center speaker is
connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
6
Use the Down [
select "Surround," and then use
the Left and Right [
tons to select Small, Large, or
None.
Small: Select if the surround speak-
ers are small.
Large: Select if the surround speak-
ers are large.
None: Select if no surround speakers
are connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7
Use the Down [
select "Surr Back," and use the
Left and Right [
select Small, Large, or None.
Small: Select if the surround back
speakers are small.
Large: Select if the surround back
speakers are large.
None: Select if no surround back
speakers are connected.
Notes:
• If the Surround setting in step 6 is set
to None, this setting does not appear.
• If the Surround setting in step 6 is set
to Small, the Large option cannot be
selected.
8
] button to
]/[ ] buttons to
9
] button to
]/[ ] but-
] button to
]/[ ] buttons to
Use the Down [
select "Surr Back Ch," and use
the Left and Right [
tons to select 2ch or 1ch.
2ch: Select if two (left and right)
surround back speakers are
connected.
1ch: Select if one surround back
speaker is connected.
Note:
• If the Surround and Surr Back set-
tings in steps 6 and 7 are set to None,
this setting does not appear.
Press the [SETUP] button.
Setup closes.
SETUP
Testing the Speakers
To test that all of the speakers are working properly,
press the remote controller's [TEST TONE] but-
ton.
LISTENING MODE
STEREO SURROUND
AUDIO SUBTITLE RANDOM
TEST TONE
TEST TONE CH SEL
PLAY MODE
DISPLAY
VCR
RC - 647 M
The test tone will be output by each speaker in turn
and the name of each speaker will appear on the dis-
play. To turn off the test tone, press the [TEST
TONE] button again.
• If the test tone is not produced by a speaker, or it's
produced by a speaker other than that shown on
the display, you may have wired the speakers
incorrectly and you should check your connec-
tions (see page 17).
• If the test tone is not produced by a speaker and its
name does not appear on the display, you may
have set the speaker configuration incorrectly (see
page 34).
• Testing cannot be performed while speaker set B
is on or a pair of headphones is connected.
] button to
]/[ ] but-
REPEAT
LEVEL - LEVEL +
L NIGHT CINE FLTR
DVD HDD
35