Table of Contents
Advertisement
1
HP-UX Installation
This chapter contains HP-UX installation information for the A6795A Fibre Channel Mass Storage Adapter
and contains the following sections:
•
"Supported Configurations"
•
"Superdome Installation"
•
"Installation Prerequisites"
•
"Patches"
•
"Installing Driver Software"
•
"Installing the Adapter Online"
•
"Installing the Adapter Offline"
•
"Attach Other Devices"
•
"Verifying Installation"
•
"Verifying Connectivity"
•
"Interpreting Hardware Paths"
Thank you for purchasing HP I/O Cards
If you are installing an HP I/O card as an add-in device, please review this document before attempting
installation.
If this card was factory installed in your server, you can skip to the Verifying Installation section.
HP welcomes your input. Please email us at: netinfo_feedback@cup.hp.com with comments or suggestions on
HP I/O Cards or related documentation.
All product documentation, including a comprehensive Support Guide, Installation Guide, Release Notes, and
Support Matrix are available online at: http://docs.hp.com
1. Click on browse by topic.
2. Click on networking and communications.
3. Click on the Fibre Channel product category.
Supported Configurations
Verify compliance with the supported configurations listed in the HP Fibre Channel Host Bus Adapter
Support Matrix, available at: http://www.docs.hp.com/hpux/netcom/index.html#Fibre%20Channel
Alternately, you can access the HP Fibre Channel Host Bus Adapter Support Matrix, as well as other Fibre
Channel documentation as follows:
a. go to http://www.docs.hp.com
b. select "browse by topic"
c.
select "Networking and Communications"
d. select "Fibre Channel"
Chapter 1
5
Advertisement
Table of Contents
