Table of Contents
Advertisement
Installation
3. Enter "D:\Autorun.exe" in the blank where "D:" is the drive
letter of your CD-ROM drive as shown above, and click OK.
4. After the CD-ROM has automatically loaded, you will see
three drivers on your screen namely:
Belkin DVCAM for Windows 98, Belkin DVCAM for
Windows
®
98 Second Edition and MGI VideoWave III SE. If
your system is Windows
for Windows
98 button. If you are using Windows
®
Second Edition, select Belkin DVCAM for Windows
Second Edition. The screen that follows will tell you that
setup is complete. On that screen select "NO, I will restart
my computer later" then click "Finish".
NOTE:
MGI Video Wave III SE requires 800X600 or higher
video resolution and 16-bit color depth or higher.
5. To install MGI Video Wave III click on "START" then "RUN".
Enter "D:\Autorun.exe" in the blank where "D:" is the drive
letter of your CD-ROM drive as shown above, and click OK.
6. Follow the on-screen instructions. After the Registration
screen you will be prompted that setup is now complete.
7. Before you click "Finish", make sure both boxes
are checked.
8. The next screens that will appear will show you a guided
tour of MGI Video Wave III; afterwards you will gain access
to Readme files which will give you more information about
the MGI editing software. After you are done with the
guided tour and Readme files, you will be asked to restart
your computer.
9. After restarting, connect your DV Digital camcorder to one
of the slots on the 1394 FirePath card. Turn your camera
"ON" before you start MGI Video Wave III SE.
(continued)
®
98 only select the Belkin DVCAM
®
10
98
®
98
Advertisement
Table of Contents
