ASROCK K7UPGRADE Installation Manual page 6

BIOS:
OS:
CAUTION!
1. While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
2. Do NOT use a 3.3V AGP card on the AGP slot of this motherboard!
It may cause permanent damage!
3. Power Management for USB 2.0 works fine under Microsoft
SP1/2000 SP4. It may not work properly under Microsoft
ME. Please refer to Microsoft
http://www.microsoft.com/whdc/hwdev/bus/USB/USB2support.mspx
4. Although this motherboard offers stepless control, it is not recommended
to perform over clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU. The CPU host frequency of this motherboard is determined by the
jumper-setting. You must set the FSB jumper according to your AMD CPU
before you use the "Manual" option as the FSB setting in BIOS setup to
perform over clocking. Please check page 26 of the User Manual in the
Support CD for details.
6 6 6 6 6
1 serial port: COM1,
1 parallel port: ECP/EPP support,
4 ready-to-use USB 2.0 ports,
1 RJ-45 port,
Audio Jack: Line In / Line Out / Microphone
AMI BIOS
Supports "Plug and Play"
ACPI 1.1 compliance wake up events
SMBIOS 2.3.1 support
CPU frequency stepless control
(only for advanced users' reference, see CAUTION 4)
® ®
Microsoft Windows 98SE / ME / 2000 / XP compliant
®
official document at
ASRock K7Upgrade-600 Motherboard
® ®
Windows XP
® ®
Windows 98/