Installing An Expansion Card - ASROCK K7UPGRADE Installation Manual

Table of Contents

Available languages

NOTE

When adjusting the jumper settings, you may use the tool, Jumper Cap Remover, to help you

removing the jumper caps more easily. This Jumper Cap Remover is bundled in your motherboard

package, and please follow the "Jumper Cap Remover Instruction" to use it properly.

PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI

interface.

AGP slot: The AGP slots are used to install a graphics card. Please insert the AGP

card with K7 AGP Interface into the slot 1.5V_AGP1 (see page 2, No. 33),

or insert the AGP card with K8 AGP Interface into the slot AGP2 (see

page 2, No. 30). Please do not install AGP cards into the slot

1.5V_AGP1 and the slot AGP2 at the same time. It may cause permanent

damage to the hardware.

Please do NOT use a 3.3V AGP card on the AGP slot of this motherboard!

It may cause permanent damage! For the voltage information of your

AGP card, please check with the AGP card vendors.

Installing an expansion card

STEP 1: Before installing the expansion card, please make sure that the power

supply is switched off or the power cord is unplugged. Please read the

documentation of the expansion card and make necessary hardware

settings for the card before you start the installation.

STEP 2: Remove the bracket facing the slot that you intend to use. Keep the screws

for later use.

STEP 3: Align the card connector with the slot and press firmly until the card is

completely seated on the slot.

STEP 4: Fasten the card to the chassis with screws.

1 0

ASRock K7Upgrade-600 Motherboard

Table of Contents

K7upgrade-600