Serial Ata (Sata) Hard Disks Installation; Hot Plug And Hot Swap Functions For Sata Hdds; Driver Installation Guide - ASROCK 775XFIRE-VSTA - V1.2 User Manual

2.13 2.13 Serial A 2.13 Serial AT T T T T A (SA Serial A Serial A A (SA A (SAT T T T T A) Hard Disks Installation A (SA
2.13 2.13 Serial A A (SA
This motherboard adopts Intel
ATA (SATA) hard disks and RAID (RAID 0, RAID 1, and Intel Matrix Storage)
functions. You may install SATA hard disks on this motherboard for internal
storage devices. This section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
It is not recommended to switch the "Configure SATA as" setting between
AHCI, RAID, and IDE mode after OS installation.
2.14 Hot Plug and Hot Swap F 2.14 Hot Plug and Hot Swap F 2.14 Hot Plug and Hot Swap Functions for SA 2.14 Hot Plug and Hot Swap F 2.14 Hot Plug and Hot Swap F
775XFire-VSTA motherboard supports Hot Plug and Hot Swap functions
for SATA Devices.
NOTE
What is Hot Plug Function?
If the SATA HDDs are NOT set for RAID configuration, it is called "Hot
Plug" for the action to insert and remove the SATA HDDs while the system
is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA HDD.
What is Hot Swap Function?
If SATA HDDs are built as RAID1 then it is called "Hot Swap" for the action
to insert and remove the SATA HDDs while the system is still power-on
and in working condition.
2.15

2.15 Driver Installation Guide

2.15 Driver Installation Guide Driver Installation Guide Driver Installation Guide
2.15 2.15 Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom
side to install those required drivers. Therefore, the drivers you install can work
properly.
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation
ICH6R south bridge chipset that supports Serial
®
unctions for SAT T T T T A HDDs unctions for SA unctions for SA unctions for SA
3 1 3 1 3 1
3 1 3 1
A HDDs A HDDs A HDDs A HDDs