Serial Ata (Sata) / Serial Ataii (Sataii) Hard Disks Installation; Hot Plug And Hot Swap Functions For Sata / Sataii Hdds - ASROCK A55M-VS User Manual

Hide thumbs Also See for A55M-VS:

Table of Contents

2.10 Serial ATA (SATA) / Serial ATAII (SATAII) Hard Disks Installation

This motherboard adopts AMD A55 FCH (Hudson-D2) chipset that supports Serial

ATA (SATA) / Serial ATAII (SATAII) hard disks and RAID (RAID 0, RAID 1 and RAID

10) functions. You may install SATA / SATAII hard disks on this motherboard for

internal storage devices. This section will guide you to install the SATA / SATAII hard

disks.

STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.

STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.

STEP 3: Connect one end of the SATA data cable to the motherboard's SATAII con-

nector.

STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard

disk.

This motherboard supports Hot Plug and Hot Swap functions for SATA / SATAII in

RAID / AHCI mode. AMD A55 FCH (Hudson-D2) chipset provides hardware support

for Advanced Host controller Interface (AHCI), a new programming interface for

SATA host controllers developed thru a joint industry effort.

NOTE

What is Hot Plug Function?

If the SATA / SATAII HDDs are NOT set for RAID coniguration, it is called "Hot

Plug" for the action to insert and remove the SATA / SATAII HDDs while the

system is still power-on and in working condition.

However, please note that it cannot perform Hot Plug if the OS has been

installed into the SATA / SATAII HDD.

What is Hot Swap Function?

If SATA / SATAII HDDs are built as RAID 1 then it is called "Hot Swap" for

the action to insert and remove the SATA / SATAII HDDs while the system is

still power-on and in working condition.

Table of Contents

Show Quick Links

Table of Contents