Omron F160-2 - MANUAL 2 Operation Manual page 70

Dimension
If Yes is Selected
Set the range for OK items in physical units. Go to step (2.)
If No is Selected
Set the range for OK items in pixel units. Go to step (5.)
230 pixels
The following explanation of how to align the coordinate scale with the di-
mensions of the workpiece will use a workpiece on an angle as an exam-
ple.
0.Scn 0 =SET= Region
Set coordinates
Set the position
of the origin.
100.0
O
-100.0
↑ ↓←→:Change ENT:Set ESC:Back
Y -100.0
2. Align the origin of the coordinates (O) with the left corner or other part of
the workpiece that will serve as the origin for the physical units.
Up/Down and Left/Right Keys: Move the origin (O).
SHIFT + Up/Down or Left/Right Keys: Move the origin quickly.
ENT Key: Sets the position.
The screen for aligning the coordinate axis will be displayed.
0.Scn 0 =SET= Region
Set coordinates
Set the angle of
coordinate axis.
↑ ↓←→:Change ENT:Set ESC:Back
3. If the workpiece is on an angle, use the Down/Right and Up/Left Keys to
specify the angle for the axis.
Down and Right Keys: Rotates the axis in the clockwise direction.
X = 155
Y = 326
X
100.0
θ=10.0
X
Section 3-4
59