Start up
Creating a
CX-D
new project
1. Preparations and settings
1. Preparations and settings
Introduction
Introduction
This manual describes how to use the CX-Designer and its functions with a visual assistance in
creating sample screens.
Necessary Equipment
Necessary Equipment
Item
- CX-Designer
- NS Hardware
- PLC
- NS Hardware – PC Serial communication cable
- NS Hardware – PLC Serial communication cable
- PC
Configuration &
Configuration &
Communication Settings
Communication Settings
NS Hardware
- Serial Port A NT Link (1:N), No. of units: 0, Communication Speed: High-speed
Serial Port B Setting is not necessary
PLC
- Host Link Port Communication Speed: High-speed NT Link, Communication Mode: NT Link (1:N), NT Link Max. No. of units: 1
Allocation Address
Allocation Address
The following PLC allocation addresses are used for sample screens shown in this manual.
Allocation
Address
00000.00
00000.01
00000.02
00000.03
00000.04
00000.05
Allocation
Address
DM100
Project
property
NS hardware
PLC
RS232C Port
Serial
Port A
Description
Power 1 Running / Stopped
Power 2 Running / Stopped
Power 3 Running / Stopped
Power 4 Running / Stopped
Power 5 Running / Stopped
Power 6 Running / Stopped
Description
Present value
System
Creating
setting
a screen
Model
NS-CXDC1-V[]
- NS8-TV1[](B)-V1
- CS Series, CJ Series
- XW2Z-S002
- XW2Z-200T
- Widows PC on which CX-Designer performs
PC
Serial
Port B
Allocation Address
00001.00
00001.01
00001.02
00001.03
00001.04
00001.05
00002.00
00002.01
00002.02
00002.03
00002.04
00002.05
Validation
COM Port
Description
Alarm 1 Occurred / Released
Alarm 2 Occurred / Released
Alarm 3 Occurred / Released
Alarm 4 Occurred / Released
Alarm 5 Occurred / Released
Alarm 6 Occurred / Released
Alarm 7 Occurred / Released
Alarm 8 Occurred / Released
Alarm 9 Occurred / Released
Alarm 10 Occurred / Released
Alarm 11 Occurred / Released
Alarm 12 Occurred / Released
Transferring
a project