Word Button/Command Button; Switch Label Button - Omron CX-DESIGNER - INTRODUCTION GUIDE Introduction Manual

Start up Creating a
CX-D new project

21. Word Button/Command Button

21. Word Button/Command Button

21-1 Switch label button

21-1 Switch label button
Click the Word button
on the list
Set as follow in the object
property list:
General tab
[Write Address]
! "$W10"
[Action]
! "Display Pop-up Menu"
Click the Push button
of the Pop-up Settings
on the General tab.
Project System
property setting
Word button is an object that writes constants to a specified address when it is
pressed,
or increases/decreases a value of the specified address. It is possible to
write a specified value to the item selected from a pop-up menu.
In this manual, you will make a button to switch labels (switching English and
Dutch here) using a pop-up menu.
Creating
Validation
a screen
The value of $SW10 (NS system memory) is
The value of $SW10 (NS system memory) is
set to display a specified label No.
set to display a specified label No.
(The settings of label No. 0 (English) and
(The settings of label No. 0 (English) and
No. 1 (Dutch) made to the initial project
No. 1 (Dutch) made to the initial project
property are applied.
property are applied.
Transferring
a project