Operating Procedure; Overall Procedure - Omron CJ - 12-2004 Manual

Operating Procedure

2-2

Operating Procedure

2-2-1

Overall Procedure

12
The operating procedure for an ID Sensor Unit is shown in the following flow-
chart.
Set switch on front of Unit
Set words allocated in DM Area
Turn PLC power OFF and ON
Set switch on front of Unit
Change DIP switch on front of Unit
Note 1. When using CX-Programmer V3.0 or later with the CS1W-V600C12, "I" will
be displayed before addresses for inputs in the ladder diagram and "Q" will
be displayed before addresses for outputs for operation data. In the CX-
Programmer's I/O Table Window, select SIOU/C200H ASCII Unit (A) and
then, from the Enter SIOU Details Window, set the Address per Unit to 2,
the Input Words to 3, and the Output Words to 7, and select the Repeat IN/
OUT for each Address per Unit option.
2. When using CX-Programmer V2.0 or later with the CS1W-V600C11, "I" will
be displayed in the ladder diagram before address for inputs and "Q" will
be displayed before addresses for outputs for operation data.
Wire
Set unit number
Turn ON PLC power
Create I/O tables
Test communications
Turn ON PLC power
Ladder program operation
Section 2-2
Turn OFF the communications test switch.
Set unit number switches on front of Unit.
Set communications mode.
Enable/disable verification when writing.
Set auto wait time
OR, turn ON Special I/O Unit Restart Bit.
Turn ON the communications test switch.
Place PLC in PROGRAM mode.
OR, turn ON Special I/O Unit Restart Bit.