Omron CJ - 12-2004 Manual page 26

System Configuration
CJ-series PLCs
Power Supply Unit
1,2,3...
ID Sensor Units are connected as I/O Units in the system configuration, as
shown below.
RUN
SYSMAC
ERR/ALM
CJ1G-CPU44
INH
PROGRAMMABLE PRPHL
CONTROLLER COMM
OPEN
MCPWR
BUSY
PERIHERAL
PORT
CPU Unit
Use the following procedure to connect an ID Sensor Unit.
1. Align the connectors and press in firmly on the Units to connect them com-
pletely.
2. Move the yellow sliders on the top and bottom of the Unit to the lock posi-
tion to secure the Units. The sliders should click into place.
3. Attach an End Cover to the Unit on the right end of the Rack.
Note The CJ-series PC may not operate properly if the sliders are not locked firmly
into place.
V600C11
V600C12
RUN ERC T/R
NORM/ERR RUN ERC T/R NORM/ERR
HEAD1
HEAD2
ERP ERH ERP ERH T/R NORM/ERR
TEST TEST
ON ON
HEAD
HEAD1
HEAD2
I/O Units
(10 Units max.)
(included with CPU Unit)
Hooks
Connector
Move the sliders to the back
until they click into place.
Section 1-2
End Cover
Hook holes
Slider
Locked
Released
7