Advice On Use; Assembly; Selecting The Right Tool - Parkside PMFW 280 A1 - MANUAL 4 Operation And Safety Notes

General safety advice for electrical power tools / Assembly
½
Ensure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
½
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
©

Advice on use

Principle of operation:
The oscillating drive causes the attached tool to vi-
brate backwards and forwards up to 21000 times
per minute. This means the tool can produce precise
work in the tightest of spaces.
Sawing / cutting:
½
Use only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
½
When sawing lightweight building materials,
observe the statutory requirements and the
manufacturer's recommendations.
½
Use the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
½
Ensure that you use even contact pressure. This
will increase sanding sheet life.
©

Assembly

©

Selecting the right tool

Metal saw blade
5
Materials:
Sheet and tube up to approx. 3 mm made of
aluminium, cooper
10 GB
Use:
· Cutting and trimming to length of tube and sheet
Plunge saw blade
6
Materials:
Wood, plastic, plasterboard and other soft materials
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Sawing of recesses in lightweight walls.
Backing plate
7
Materials:
Wood, paint
Use:
· Sanding at edges and in difficult to access areas
Segment saw blade
8
Material:
Wood
Use:
· Cutting and plunge sawing