Personal Safety; Careful Handling And Use Of Electrical Power Tools - Parkside PEXS 270 A1 - MANUAL 7 Manual

oil, sharp edges or moving parts of the
device.
When working outdoors with an
electrical power tool always use ex-
tension cables that are also approved
for use outdoors.
Use a residual current device (RCD)
for protection if operating the electri-
cal power tool in a moist environment
is unavoidable.

3. Personal safety

Remain alert at all times, watch what
you are doing and always proceed
with caution. Do not use the device if
you are tired or under the influence of
drugs, alcohol or medication.
Wear personal protective
equipment and always wear
safety glasses.
Avoid unintentional operation of the
device. Check that the electrical power
tool is switched off before you connect
it to the mains, pick it up or carry it.
Remove any setting tools or spanners
before you switch the device on.
Avoid placing your body in an unnat-
ural position. Keep proper footing and
balance at all times.
Wear suitable clothing. Do not wear
loose clothing or jewellery. Keep your
hair, clothing and gloves clear of mov-
ing parts.
If vacuum dust extraction and collection
devices are fitted do not forget to check
that they are properly connected and
correctly used.
4. Careful handling and use
of electrical power tools
Do not overload the device. Always
use an electrical power tool that is
intended for the task you are under-
taking.
Do not use an electrical power tool if
its switch is defective.
Pull the mains plug from the socket
before you make any adjustments to
the device, change accessories or when
the device is put away.
When not in use always ensure that
electrical power tools are kept out of
reach of children. Do not let anyone use
the device if he or she is not familiar
with it or has not read the instructions
and advice.
Look after the device carefully. Check
that moving parts are working prop-
erly and move freely. Check for any
parts that are broken or damaged
enough to detrimentally affect the
functioning of the device. Have dam-
aged parts repaired before you use