Page 1
900 Se B ELT SANDER O peration and Safety Notes...
Page 2
B efore reading, unfold the page containing the illustrations and familiarise yourself with all functions of the d evice. GB / IE / CY Operation and Safety Notes Page ...
Vacuum dust extraction ...Page 10 Operation Switching on and off ...Page 11 Selecting the correct rotational speed and sanding belt ...Page 11 Using the sander in a fixed mounting ...Page 12 Tips and tricks ...Page 12 Maintenance and cleaning Service centre ...Page 13...
Danger to life! Explosive material! Rated idle running speed Voltage Watts (Effective power) Belt sander PEBS 900 SE Introduction Please make sure you familiarise your- self fully with the way the device works before you use it for the first time and that you understand how to handle electrical pow- er tools correctly.
This can result in a much lower vibration load over the whole of the period of working. The PEBS 900 SE belt sander has full-wave elec- tronics with additional control electronics, soft start with inrush current limiting.
General safety advice for electrical power tools 2. Electrical safety To avoid danger to life from electric shock: a) The mains plug on the device must match the mains socket. The plug must not be modified in any way. Do not use an adapter plug with devices fitted with a protective earth.
When undertaking prolonged sanding of wood, and in particular when working on ma- terials that give rise to dusts that are hazardous to health, the sander must be connected to a suitable external dust extraction device. Ensure that there is adequate ventilation when working on plastic, paint, varnish etc.
WarNING! rISK OF INjUry! Before you carry out any work on the belt sander always pull the plug out of the mains socket. 1. Then release the tensioner for the sanding belt by moving the tensioning lever wards (see fig.
Operation Switching on and off The PEBS 900 SE belt sander has full-wave electro- nics with additional control electronics, soft start with inrush current limiting. When operating the belt sander you can select between intermittent or continuous operation mode.
(e.g. workbench). Sanding horizontally (see Fig. E): Place the belt sander on to the mounting frame and guide the dust extraction spout through the opening of the mounting frame...
Maintenance and cleaning WarNING! rISK OF INjUry! Before you carry out any work on the belt sander always pull the mains plug out of the mains socket. The belt sander is designed to be maintenance-free. Clean the device frequently. This should be done immediately after you have finished using it.
(2004 / 108 / EC): EN 50366, EN 55014-1, EN 61000-3-2, EN 61000-3-3, EN 55014-2 Type / Description of product: Parkside belt sander PEBS 900 SE Bochum, 31.10.2009 Hans Kompernaß - Managing Director - We reserve the right to make technical modifications in the course of further development.