Using the bodypack transmitter
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the instruction manual of
the receiver).
2. Switch the bodypack transmitter on (see next section).
The transmission link is established and the receiver's
RF level display "RF" reacts.
It is vital to observe the notes on frequency
selection on page 26.
If you cannot establish a transmission link between
bodypack transmitter and receiver, refer to the chapter
"Synchronizing the bodypack transmitter with the receiver
– individual operation" on page 26.
Switching the bodypack transmitter on/off
Push the two battery compartment catches
the battery compartment cover
To switch the bodypack transmitter
Briefly press the
ON/OFF
The
RF signal.
The
appears on the display panel. The red
lights up and the transmission icon
displayed.
You can switch the bodypack transmitter on and
deactivate the RF signal on switch-on. For more
information, see page 12.
Using the bodypack transmitter
ON/OFF
bodypack
transmitter
standard
display
.
on
(online operation):
button
.
transmits
"Frequency/Name"
and open
an
ON
LED
is
11