Sennheiser EM 3731-II - 09-09 Instruction Manual page 38

Channel list
Scan new
Scan reset
7 8
save
DEV
777.005 M
H
z
sync
U.01 BANK AF
COM
esc
CH
Freq. occupied
1.
776.000
MHz
Channel list
Scan new
Scan reset
Bank 1 2 3
Free 43 40 42
Bank 4 5 6 U
Free 32 31 33 60
7 8
save
DEV
777.005 M
H
z
sync
U.01 BANK
AF COM
esc
CH
Starting the scan
Via the "Scan new" menu, you can scan all frequency banks for free
channels. The last scan result is overwritten.
Before starting the scan, switch all transmitters of your system off,
since channels used by switched-on transmitters will not be displayed
as "free channels".
Turn the jog dial
Press the jog dial
The receiver scans the frequency banks one after the other for free
channels. This can take several minutes. After the scan, a table displays
the number of free channels for each frequency bank and the green
backlighting of the
You can cancel the scan at any time by pressing the
The display changes to the setting mode of the "Scan" menu and
the last scan result is restored.
Turn the jog dial
of free channels.
Press the save
The selected frequency bank is automatically called up in the "Bank.Ch"
menu.
digital audio
processing
Select a channel from this frequency bank (see "Selecting a frequency
sync
bank and a channel" on page 30).
After the scan, the channels that are occupied or subject to
B.Ch
interference are marked with a warning triangle and
occupied".
Releasing channels that are used or subject to interference
After the scan, the channels that are occupied or subject to interference
are marked with a warning triangle and
"Scan reset" menu, you can unmark these channels. The last scan result is
deleted.
Turn the jog dial
Press the jog dial 7.
The number of free channels is reset to the maximum for all frequency
banks.
Turn the jog dial
Press the save
digital audio The selected frequency bank is automatically called up in the "Bank.Ch"
processing
menu.
sync
Adjustment tips for the operating menu
7
until the arrow points to
7
to start the scan.
8
save button flashes.
7
to select a frequency bank with a sufficient number
button 8.
7
until the arrow points to
7
to select a frequency bank.
button 8.
"Scan new".
button 6.
esc
"Freq.
"Freq. occupied". Via the
"Scan reset".
37