Sennheiser EM 3731-II - 09-09 Instruction Manual page 34

Booster Feed On
7 8
save
DEV
777.005 M
H
z
sync
U.01 BANK AF
COM
esc
CH
+12
ooster AF Out
+12 dB
7 8
save
DEV
777.005 M
H
z
sync
U.01 BANK AF
COM
esc
CH
Change to the setting mode of the "Booster" menu.
The current setting starts flashing.
Turn the jog dial
"Booster Feed
digital audio Press the save
processing
The selected setting is stored. When the booster supply voltage is
sync
switched on, the two LEDs
the selection mode of the operating menu.
Adjusting the audio output level
Via the "AF Out" menu, you can adjust the maximum output level of the
audio outputs (AF Out and Command).
48
With the EM 3732-II COM twin receiver, the audio level of the Command
Clock
L
output 1 corresponds to the level of the audio output 1
audio level of the Command output 2
audio output 2 K.
The following figures are a guide to the best settings:
• Line level: +5 to +18 dB
• Microphone level: –10 to +4 dB
To obtain the best signal-to-noise ration, adjust the respective maximum
audio level to the settings shown above.
Change to the setting mode of the
The current setting starts flashing.
+12
Turn the jog dial
The display shows the selected audio output level.
digital audio
Press the save
processing
The selected setting is stored. The display changes to the selection
sync
mode of the operating menu.
Adjustment tips for the operating menu
7
to change the setting to
Off".
button 8.
N S
and light up. The display changes to
J
corresponds to the level of the
"AF Out" menu.
7
to adjust the audio output level.
button 8.
"Booster Feed On" or
M
and the
33