Working With The Operating Menu - Sennheiser EM 3731-II Instruction Manual

Using the operating menu
M
776.000
H
z
01.01 BANK HD
P
CH
776.
000
MHz
Tune
776.
000
MHz
Tune
B.Ch
U.01
776 960
UHF MHz
B.Ch
U.01
776 960
UHF MHz
clock
save
6.000 M
H
z
sync
.01 BANK HD
AF COM
esc
P
CH
6
24

Working with the operating menu

By way of example of the "Tune" menu, this section describes how to use
the operating menu.
After switching the receiver on, the status display is shown on the display
panel.
AF COM
Getting into the operating menu
Press the jog dial 7.
B.Ch
The status display is replaced by the operating menu.
1.01
The "Tune" menu is displayed together with its current setting. The
Bank
position of a menu within the operating menu is illustrated by a graphic
in the upper display margin (the "Tune" menu is on the very left of the
operating menu).
Selecting a menu
Turn the jog dial
B.Ch
the display.
1.01
Bank
Press the jog dial
776.
The icon of the menu is displayed and the current setting starts
000
MHz
flashing. In addition, the green backlighting of the
flashes.
Adjusting a setting
Turn the jog dial
777.
225
Press the jog dial
MHz
Depending on the selected menu, the next setting that can be changed
and confirmed by turning and pressing the jog dial
Storing a setting
Press the save
An animation appears on the display, indicating that the setting has
been stored. The display then changes to the selection mode of the
operating menu.
Exiting the operating menu/cancelling an entry
You can exit the operating menu or cancel an entry at any time.
Press the esc
An animation appears. The display then returns to the previous menu
level. To return to status display, you may have to press the
6
esc button
7
until the icon of the desired menu is in the center of
7
to get into the setting mode of the selected menu.
7
until the desired setting appears.
7
to confirm the selected setting.
8
button to store the setting.
button 6.
several times in succession.
8
save button
7
flashes.