Working With The Operating Menu - Sennheiser EK 100 G2 Operating Instructions Manual
Bodypack receiver
Hide thumbs
Also See for EK 100 G2:
- Operating instructions (3 pages) ,
- Operating instructions (2 pages) ,
- Operating instructions (2 pages)
Table of Contents
Advertisement
EM 100 G2
EK 100 G2
Trans-
mitters
26
Working with the operating menu
By way of example of the "TUNE" menu, this section describes how to use the
operating menu.
After switching the unit on, the standard display is shown on the display
panel.
Getting into the operating menu
Press the
SET
button to get from the standard display into the operating
menu. The last menu selected flashes on the display.
Selecting a menu
Press the
/
buttons to select a menu.
Press the
SET
button to get into the setting mode of the selected menu.
The current setting that can be adjusted flashes on the display.
Adjusting a setting
Press the
/
buttons to adjust the setting. By briefly pressing the /
buttons, the display jumps either forwards or backwards to the next set-
ting. In the "CHAN", "TUNE" and "NAME" menu, the
a "fast search" function. If you hold down a button, the display cycles con-
tinuously. The "fast search" function allows you to get fast and easily to
your desired setting. The new setting flashes on the display until it is
stored.
Storing a setting
Press the
SET
button to store the setting. "STORED" appears on the dis-
play, indicating that the setting has been stored. The display then returns
to the previous menu level.
With most menus, new settings become effective immediately without
having to be stored. An exception are the "BANK", "CHAN", "TUNE" and
"RESET" menus of the transmitters and the "RESET" menu of the recei-
vers. With these menus, new settings only become effective after they
have been stored ("STORED" appears on the display, indicating that the
setting has been stored).
Exiting the operating menu
Select the "EXIT" menu to exit the operating menu and to return to the
standard display.
When you have entered the operating menu, the
POWER
button (EM 100 G2 receiver only) serves as the ESC (cancel) key,
i.e. by briefly pressing the
and return to the standard display.
ON/OFF
ON/OFF
or
POWER
button, you cancel your entry
/ buttons feature
button or the
Advertisement
Table of Contents
