Sk 100 G3 Bodypack Transmitter - Sennheiser 100-P - 01-09 Instruction Manual

Putting the devices into operation
ME 2/ME 4
12

SK 100 G3 bodypack transmitter

Inserting the batteries/accupack/Charging the accupack
The procedure is the same as for the EK 100 G3 diversity receiver:
To insert the batteries/accupack:
Read the chapter "Inserting the batteries/accupack" on page 10.
To charge the accupack:
Read the chapter "Charging the accupack" on page 10.
Connecting the microphone cable/line cable
The audio input is designed for the connection of condenser microphones. DC powering of the
condenser microphones is via the audio input
Use one of the recommended Sennheiser microphones or the optional CL 2 line cable.
Connect the 3.5 mm jack plug
MIC/LINE .
Lock the 3.5 mm jack plug by screwing down the coupling ring
Via the operating menu, adjust the sensitivity of the microphone/line input.
Attaching and positioning the corresponding microphones
Use the microphone clip
The ME 2 clip-on microphone (shown on the right in the diagram) has an omni-directional
pick-up pattern. It is therefore not necessary to position it precisely.
Attach the ME 2 microphone as close as possible to the sound source.
The ME 4 clip-on microphone (shown on the left in the diagram) has a cardioid pick-up
pattern.
Position the ME 4 microphone so that its sound inlet is directed towards the sound source
(e.g. mouth).
MIC/LINE
from the Sennheiser cable to the 3.5 mm jack socket
to attach the microphone to clothing (e.g. tie, lapel).
(3.5 mm jack socket).
of the cable.