Safety Instructions - TEFAL SMART CLEAN Manual

For UK users only - Wiring instructions
Warning:
this appliance
must be earthed.
Important:
the wire in this lead are
coloured in accordance with
the following codes :
Green and Yellow: Earth
Blue: Neutral
Brown: Live
• Connect the Green/Yellow wire to the terminal in
the plug marked "E" (or by the earth symbol) or
coloured Green or coloured Green and Yellow.
Connect the Brown wire to the terminal in the plug
marked "L" or coloured Red. Connect the Blue wire
to the terminal in the plug marked "N" or coloured
Black. A 13 amp fuse should be fitted when the
appliance is connected to a BS 1363 plug. Seek
professional advice if you are unsure of the correct
procedure of the above.
Voltage
• This appliance is designed to work on 230-240 volts
AC only. Check that the mains supply corresponds
to that shown on the rating plate of the appliance. If
the appliance is to be used in any country other
than that of purchase, it should be checked by an
approved Service Dealer. Standards can vary from
country to country.

Safety instructions

• This equipment complies with current safety
regulations and requirements as well as
directives:
- 89/336/CEE modified by 93/68/CEE
- 73/23/CEE modified by 93/68/CEE
• This electrical equipment operates at high
temperatures which may cause burns. Never
touch the metallic parts before they have cooled
down completely.
• Do not leave the equipment switched on while
unattended.
• Use and store it out of children's reach
• Always plug in the equipment at an earthed
power socket.
• Do not use an extension lead. If you accept
liability for doing so, only use an extension lead
which is in good condition, has an earthed plug,
and is suited to the power of the equipment.
• Check that the mains voltage corresponds with
that shown on the equipment (alternating current
only).
• If the equipment is used in a country other than
that of purchase, have it checked by an approved
Service Centre.
Green and
E
Brown
yellow
L
or green or red
Fit correct
Blue or fuse
N
black
Use cable
gripper
About your factory fitted plug.
FOR UK ONLY
(supplied with certain models only)
• The lead is already fitted with a plug incorporating
a 13 amp fuse. If the plug does not fit your socket
outlet, see next paragraph.
• Should you need to replace the fuse in the plug
supplied, a 13 amp approved BS 1362 fuse must
be used.
• The fuse cover is an important part of the plug.
Please ensure that it is always refited. If you lose
this cover please do not use the plug. You may
contact TEFAL for a replacement.
• If the plug supplied does not fit your socket outlet,
it should be removed from the mains lead and
disposed of safety. The flexible cord insulation
should be stripped back as appropiate and a
suitable alternative plug fitted. The replacement
plug must be equipped with a 13 amp fuse.
Important:
if the electrical cord of this appliance is damaged, it
must only be replaced by an authorised Service Dealer.
The safety of this appliance complies with the technical
regulations and standards in force.
• Never use or plug in your equipment if:
- its power lead is faulty or damaged,
- the equipment has been dropped,
- it has visible damage or operating faults.
• In such cases, to avoid any danger contact your
nearest approved Service Centre to have the
equipment repaired, as special tools are needed.
Never disassemble the equipment yourself. This
will negate the guarantee.
• If the power lead is damaged, it must be replaced
by an authorised service centre, in order to avoid
any danger.
• In the event of fire, never try to extinguish the
flames with water. Close the lid. Smother the
flames with a damp cloth.
• Do not switch on the equipment near to
inflammable materials (blinds, curtains, etc.) or
close to an external heat source (gas stove,
hotplate, etc.)
• This equipment has been designed for domestic
use only. Any professional use, inappropriate use
or failure to comply with the instructions, the
manufacturer accepts no responsibility and the
guarantee does not apply.
E
NG
3