Using The Hob; Ignition Of The Burners - Smeg SRV572XGC Manual

Instructions for the user

7. USING THE HOB

Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly.
In the ultrarapid burner, notch A must be aligned with pin B.
Grid C (where available) is intended for use with woks (Chinese pans).
Adapter D comes only with open grids models and is intended for use with small sized vessels.

7.1 Ignition of the burners

Raised indicators make for easier and clearer reading and use of the controls, each knob being
connected to its corresponding burner by a rib. Setting corresponds to the elongated part of the knob or
to the marking on it.
(Only where applicable)
Double-crown burners, controlled by two knobs, feature two ribs, a long one corresponding to the small
inner burner and a short one to the outer burner.
Double-crown burners comprise an auxiliary and a rapid burner, controlled by two different knobs which
allow both burners to be used at the same time or to select one or the other as required.
The device is fit with electronic ignition. Simply press and simultaneously turn the knob counter-
clockwise on the low point flame symbol, until the burner is ignited.
Concerning models with valves, push the knob for approximately 2 seconds in order to keep the flame
burning and to activate the safety device.
The burner might go off when the knob is released. In this case repeat the aforesaid operation keeping
the knob pressed for more than 2 seconds.
Should the burners go off accidentally in the models with valves, a safety device will trip after
approximately 20 seconds to block the gas outlet even if the cock is open.
21