Table of Contents
Advertisement
Instructions for the installer
3. ELECTRICAL CONNECTION
Make sure that the voltage and capacity of the power line conform to the data shown on the plate located
under the casing. Do not remove this plate for any reason.
The plug on the end of the supply cable and the wall socket must be the same type and conform to the
current electrical system regulations. Check that the power line is adequately grounded.
On the power line, install an omnipolar cut-off device with contact cut-off distance greater than or equal
to 3 mm, located in an easily accessible position near the unit.
Do not use reducers, adapters or shunts.
2
If the power cable is replaced, the wire section on the new cable must not be less than 1.0 mm
(3 x 1.0
cable), keeping in mind that the end to
be connected to the hob must have the ground wire (yellow-green) longer by at least 20 mm. Use only
cable which has a maximum temperature of 90°C. Any replacement needed should be carried out by a
specialised technician who should make the mains connections.
The manufacturer will not be liable for any damage to persons or property caused by non-
observance of the above instructions or deriving from the tampering of even a single part of the
hob.
16
Advertisement
Table of Contents
