Adaptation To Different Types Of Gas; Removing The Hob; Regulation For Lpg (20Y) - Smeg SRV572XGC Manual

Table of Contents

5. ADAPTATION TO DIFFERENT TYPES OF GAS

Before performing any cleaning or maintenance work, disconnect the appliance from the electrical

socket.

For functioning with other types of gas the nozzles must be replaced and the primary air adjusted.

To replace the nozzles and regulate the burners, you have to remove the top as described in the

following paragraph.

1 Remove all the knobs, the grids, the burner caps and the flame-caps;

2 Remove the screws and the nuts A that secure the burner supports;

3 Lift the hob from its seat;

4 Replace the burner nozzles in accordance with the relevant gas table;

5 Regulate the primary air as described in paragraph "5.2 Regulation for LPG".

Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle C and

assemble the suitable one, following the instructions indicated in the reference charts, with respect to the

type of gas to use. The screwing torque of the nozzle should never exceed 3 Nm. Reposition support B

so that nozzle C is covered perfectly.

Move the Venturi tube D to regulate the air flow until distance "X" is reached indicated in the chart in

paragraph "5.5 Regulation of primary air" and then secure the tube by means of screw A. After the

regulations have been carried out, restore the seals with sealing wax or equivalent material.

Burner

Semirapid

Rapid

Double

Internal

crown

External

Instructions for the installer

Rated heating capacity

1.5

2.3

1.0

3.0

LPG - (20Y) 2.8 kPa

Nozzle diameter 1/100 mm

Table of Contents

Srv573xgc