Table of Contents
Advertisement
Instructions for the user
8
.2
8.2.1
With mobile levers of type 1
W
ith the door completely open, lift the levers A until they touch the
h
inges B and take hold of the two sides of the door with both hands close
to
the hinges. Raise the door to an angle of about 45° and remove it. If
th
e hinges hav
keepi
ng the door slightly raised. To reassemble, fit the hinges
g
rooves, then lower the door into place, ensuring that it re
into the grooves C, then lower the levers A.
8.2.2 With pins
Open the door completely and insert the pins (supplied) into the holes
from the inside. Close the door to an angle of about 45° and lift it off. To
reassemble, fit the hinges into their grooves, then lower the door into
place and extract the pins.
8.3 Oven door seal
To permit thorough cleaning of the oven, the seal
may be removed. Before removing the seal, take off
the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown
in the figure.
After cleaning, refit the seal with the longer side
horizontal and insert the tabs into the appropriate
holes starting from the top ones.
30
Removing the door
e not locked, repeat the operation, raising the levers A and
B into their
mains fitted
Advertisement
Table of Contents
