Accessories - Lincoln Electric SQUARE WAVE TIG 175 Service Manual

C-2
OPTIONAL ACCESSORIES
K964-1 Undercarriage with single gas cylinder
Platform - This undercarriage is designed specifically
for the Square Wave TIG 175 power source. Its cast-
ers and wheels are factory assembled to a platform
base that mounts the power source. A separate gas
cylinder platform and bracket with chain mount to the
undercarriage to accommodate 6 to 9 inch diameter
gas cylinders from 24 to 56 inches high.
tm
K812 Hand Amptrol - A Lincoln Foot Amptrol is
included with the Square Wave TIG 175 for remote
current control while TIG welding. The K812 Hand
Amptrol may be used in place of the Foot Amptrol if a
thumb operated remote control is desired.
K814 Arc Start Switch - The Arc Start Switch may be
used instead of the Foot Amptrol included with the
Square Wave TIG 175. It allows on/off TIG welding at
the current set by the Current Control on the control
panel. The Arc Start Switch does not provide remote
current control.
Magnum® LA-9 and LA-17 TIG Torches - The fol-
lowing standard Magnum® TIG torches with one-
piece cable may be used with the Square Wave TIG
175.
• K859-1 LA-9 12.5 ft medium back cap
• K859-5 LA-9 25 ft
• K860-1 LA-17 12.5 ft long back cap
• K860-5 LA-17 25 ft
NOTE: Each torch requires a quick connector plug
(S22529-1) and strain relief boot (M17255) be
installed onto the cable. Collets, collet bodies, and
nozzles are not included and must be ordered sepa-
rately.
Quick Connect Plug (S22529-1) and Strain Relief
Boot (M17255) - One of each is required to connect
Magnum LA-9 or LA-17 TIG torches with one-piece
cable to the Square Wave TIG 175. The quick con-
nect plug provides connection for both gas and weld-
ing current.
Tungstens, Collets, Collet Holders, Gas Cups,
Backcaps and Other Torch Parts - A Lincoln
Magnum LA-9 with 12.5 ft. one-piece cable is included
with the Square Wave TIG 175. Standard Magnum®
parts and accessories for this torch may be used.
TIG Torch Parts Kits - Parts kits are available for the
LA-9 and LA-17 TIG torches. These kits include back
cap, collets, collet bodies, nozzles and tungstens.

ACCESSORIES

medium back cap
long back cap
SQUARE WAVE TIG 175
Order KP507 for LA-9 torches
Order KP508 for LA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel,
aluminum and copper alloys. See publication C9.10.
C-2