Smeg S106X-6 Instructions For Use Manual page 9

Instructions for the User
7.0.2 Setting the time
When the oven is used for the first time, or after an interruption in the
electricity supply, the display flashes at regular intervals.
Press for 1 / 2 seconds to stop the display flashing and start the
procedure for setting the correct time. Press the value modification keys
or to increase or decrease the setting by one minute for each
pressure.
Press one of the two value modification keys until the current time
appears. 6/7 seconds after the last key is pressed, the clock will start from
the time set.
At the end of each programmed operation 8 beeps will sound 3/4 times at
intervals of about 1 and a half minutes. This sequence can be stopped at
any time by pressing any key.
7.0.3 Timer
This function does not stop cooking; it simply activates the buzzer.
• Press and the display will light up as shown in
figure 1;
• Within 6/7 seconds, press the
the timer. Each time a key is pressed, 1 outside
segment, representing 1 minute of cooking time,
will light up or go out. (figure 2 shows a cooking
time of 10 minutes).
• 6/7 seconds after the last key is pressed, the
countdown will start; when it finishes, the buzzer
will sound.
• During the countdown, the current time can be
viewed by pressing the
to return to the timer display.
• At the end of the countdown, the oven must be
switched off
thermostat and function selector knob to 0.
or
key once; press it again
manually by
keys to set
1)
2)
turning the
43