Table of Contents
Advertisement
O
7
©
9
ь
рәиға
јоциод
eui
би5п
Using the Control Panel
Top of Form Function (TOF SET)
This printer has a Top of Form (TOF) function which stores the first print line position and loads the paper to the
designated position automatically. The first print line position will be stored even after the power is turned off.
Additionally, the printer can store 3 different Top of Form positions depending on the paper feed method [fanfold
paper-push (ЕЗ), single sheet (f |) and multiple single sheets (СІ) using the built-in sheet feeder or the optional
Auto Cut Sheet Feeder (KX-PT12)].
You can adjust the Top of Form position by using the Setup Disk (её P. 31~40), or using Micro Line Feed or
Reverse Micro Line Feed within 5" from the top of your paper.
Note:
е Do not rotate the platen knob, otherwise the printer will not be able to count the number of lines.
eWhen setting TOF for fanfold paper, all adjustments must be made on the first sheet. If you wish to change
the setting after advancing additional sheets you must first park then reload the paper.
1
If
necessary,
redefine
the
page
length of the paper you are using
through
the Setup
Disk (е Р. 31~
40), control
panel
(ғғ P. 48—49)
ог
your application software (i P. 51~
53).
2
Micro Line Feed
TEAR
оние
LINE
osne)
e
[i
LF/FF
Fa
Fa
Reverse Micro Line Feed
3
At your desired position, release the
switches.
44
A page is defined by setting the page length through .
the Initial Setup mode or the Software command.
While pressing
(ОМ LINE), press
|LF/FF | ,
This advances the paper one micro line (1807).
Holding
the
switches
will
advance
the
paper
continuously until you release the switches.
While pressing | ON LINE),
press
'LOAD/PARK |
This reverses the paper one micro line (14807).
Holding
the
switches
will
reverse
the
paper
continuously
until you
release the switches.
The
printer cannot reverse the paper past the printable
area.
The paper position will be stored automatically as the
new Top of Form position.
Advertisement
Table of Contents
