Table of Contents
Advertisement
Using the Control Panel
Line Ееед/Еогт Feed | | ЕГЕЕ
You can adjust the paper position by using the front panei switches when the printer is in the OFF LINE mode or
when the printer is not printing in the ON LINE mode.
Line Feed
TEAR
LOAD
ON LINE
өн
РАВК
With
paper installed,
pressing
(LF/FF)
once
advances the paper one line.
Form Feed
With
paper
installed,
holding
(ШҒ/ҒҒ)
moves
the
printhead to the center and advances the paper to the
Micro Line Feed
p deu
5"
With paper installed, while pressing | ON ИМЕ | press
LF/FF ) once to advance the paper one micro line
(1A80"). Holding the switches will advance the paper
ON LINE
lec
LF/FF
BEAL
continuously until you release the switches. Using the
@
г
Micro Line Feed within 5" from the top of your paper
automatically stores the position as Top of Form
position.
Joued
040
эц
биоп
Reverse Micro Line Feed
With paper installed, while pressing (ON LINE), press
once to reverse the paper one micro
line (1480"). Holding the switches will reverse the
paper continuously until you release the switches.
Using the Reverse Micro Line Feed within 5" from the
top of your paper automatically stores the position as
Top of Form position.
Note:
eWhen pressing (СЕ/ЕЕЈ, the amount of paper which is fed is determined by the current setting for lines per
inch as specified by the Setup Disk, control panel (Initial Setup Mode) or your application software.
Advertisement
Table of Contents
