Table of Contents
Advertisement
O
>
t»
©
Go
эрой
dnies
тещи!
Using the Setup Disk
This Setup Disk can only be used in an IBM-PC or a compatible computer with a 3.5" floppy disk drive.
Before using the Setup Disk, it is recommended that you make a back-up copy and store the original in a safe
place.
This printer has been factory set to operate with most of the popular software packages. In most cases there will
be no need to change the initial setup items. Refer to pages 31~33 to verify that the factory settings meet your
requirements. If no changes are required, you should be ready to print.
Note:
eUse the DISKCOPY command of the operating system to make a back-up copy. Refer to your DOS manual
for further information.
e You may find it convenient to install the Setup Disk programs directly onto your C Drive, rather than reading
them from the Setup Disk each time a change is necessary. Either method is acceptable.
To perform an automatic installation of the Setup Disk files onto your C Drive, follow the steps below:
1. Insert the Setup Disk into drive A or B.
2. Type A: (or B:) and press (Enter).
3. Type INSTALL and press (Enter).
This procedure automatically creates a directory called 2130&35 and copies all of the programs from your
Setup Disk onto your C Drive.
To recall the programs from your C Drive.
«For DOS»
;
At your C:\> prompt, type CD 2130835 and press
Type SETUP and press
«For WINDOWS»
Select
from the File menu.
Type C:\2130&35\SETUP and click
(or press (Enter).
өВе sure to type SETUP as one word. If not, you will receive a Syntax error message.
Running the Initial Setup Program
1
insert your Setup Disk into either drive A or B.
<For DOS>
<For WINDOWS>
2
Type A: (or B:) and press (Enter).
2
Select
from the File menu.
3 Туре SETUP.
З Туре AASETUP (or BASETUP).
4
Press (Enter).
4
Click
(or press (Enter )).
34
Advertisement
Table of Contents
