Camera Recording (Basic, Stand-By, Programmed Recording) - Panasonic Palmcorder PalmSight Quasar VM-L451 Operating Instructions Manual

Camera Recording
Before you begin...
s Connect Camcorder to power source.
¢ Insert cassette with record tab (page 10).
1 Press LCD-OPEN to unlock the LCD
monitor. Swing LCD monitor fully
open and adjust viewing angle.
+ If you want to record using EVF, close
and lock LCD monitor.
2 Set POWER to
CAMERA.
Lens Cover opens.
Power Lamp lights.
is fully turned to (Record/Pause mode
CAMERA position. i l
CAUTION :
Rotating partially open LCD
monitor may block cassette door
and damage Camcorder body.
* EVF or LCD monitor turns on/off by the
oe Built-in Twin opened and turns back on when LCD
>
Capsule 2-Way
is closed.
Microphone * Both EVF and LCD monitor turn on
when LCD is at 180° (see above left).
This allows both you and the subject to
view the recording.
3 LCD : Turn BRIGHT control to
monitor adjust LCD monitor `
brightness level.
EVF : Look into EVF and adjust
VISION ADJUSTMENT to
your eyesight.
4 Hold down TAPE SPEED for about 1
second to change tape speed to SP/SLP
(page 10).
Tape speed
5 Press RECORD/ 9
PAUSE to start or RECORD
pause recording.
6 Set POWER to
Note: a EVF or LCD Monitor
e When Camcorder is aimed at excessively OFF when finished. (Record mode)
bright objects, or bright lights, a vertical. To remove the cassette, slide the TAPE
bar may appear in the picture. This is EJECT switch (page 10).
normal for the CCD pick-up. Try to avoid eee
this when possible. WARNING:
* Using LCD monitor reduces battery e Do not leave the camcorder with the EVF
operation time. Return LCD monitor to aimed directly at the sun. This may cause
locked position when not in use. damage to the internal parts of the EVF.
E Brar assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com