22
|
Configuration
22.2.2 To access the field setting components
22.2.3 Field setting components
Installer and user reference guide
118
Mode
Mode 2
(field settings)
See also:
▪
"22.2.4 To access mode 1 or
▪
"22.2.5 To use mode
▪
"22.2.6 To use mode
▪
"22.2.7 Mode 1: Monitoring
▪
"22.2.8 Mode 2: Field
See
"17.2.2 To open the outdoor
Location of the 7‑segment displays, buttons and DIP switches:
a
b
DS1 DS2
BS1 BS2
BS3
22‒1 1 Phase (V)
a
DS1 DS2
22‒2 3 Phase (Y)
BS1
MODE: For changing the set mode
BS2
SET: For field setting
BS3
RETURN: For field setting
DS1, DS2
DIP switches
a
7‑segment displays
b
Push buttons
c
DIP switches
DIP switches
Only change the factory settings if you install a cool/heat selector switch.
DS1‑1
COOL/HEAT selector (refer to the manual of the cool/heat
selector switch).
ON= COOL/HEAT selector active; OFF=not installed=factory
setting
Mode 2 is used to change the field settings of the
system. Consulting the current field setting value and
changing the current field setting value is possible.
In general, normal operation can be resumed without
special intervention after changing field settings.
Some field settings are used for special operation (e.g., 1
time operation, recovery/vacuuming setting, manual
adding refrigerant setting, etc.). In such a case, it is
required to abort the special operation before normal
operation can restart. It will be indicated in below
explanations.
4
2" [
119]
4
1" [
120]
4
2" [
121]
4
settings" [
122]
4
settings" [
123]
4
unit" [
71].
c
b
c
BS1 BS2
BS3
Description
VRV 5-S system air conditioner
4P600330-1A – 2020.07
RXYSA4~6A7V/Y1B