Culligan Medallist Plus Series; Cullar Filter Pds - Culligan Medallist Plus Series Owner's Manual

Performance
Data Sheet
(cont.)
14
Inside Text

Culligan Medallist Plus Series

Important Notice — Read this data sheet and compare the capabilities of the unit to your actual
water treatment needs. Culligan recommends that you have your water supply tested to determine
these needs before purchasing a water treatment unit.
Culligan knows the more informed you are about your water treatment system, the more confident you
will be about its performance. It's because of this and more than seventy years of commitment to our
customers that Culligan is providing this Performance Data Sheet to its customers.
Manufacturer Culligan International Company
999 W. Higgins Rd., Suite 1100, Rosemont, IL 60018 USA
1-800-CULLIGAN or 1-847-40-2800
Substance Reduction
This system has been tested according to WQA S-200 for the reduction of the substances listed
below. The concentration of the indicated substances in water entering the system was reduced to a
concentration less than or equal to the permissible limit for water leaving the system, as specified in
WQA S-200.
While testing was performed under standard laboratory conditions, actual performance may vary.
Substance
Chlorine Taste & Odor
* United States Environmental Protection Agency Safe Drinking Water Act.
Capacity: 180,000 gallons
Flow Rate: 6.0 gpm
Rated Pressure Drop: 6.0 gpm @ 6 psi
Operating Conditions
Water Pressure Limits: 20 - 120 psi (140 - 860 kpa)
Canada: 20 - 90 psi (140 - 620 kpa)
Temperature Limits:  - 120° F (1 - 50° C)
Electrical Characteristics:
The Medallist Plus Cullar ® Filter is tested and certified by WQA against WQA S-200 for neutralization up to
180,000 gallons as verified and substantiated by test data.
Performance Indicator: If water flow decreases or a noticeable taste change occurs, the filter should be
backwashed. If conditions do not improve, contact your local Culligan Man. He can determine if your filter
requires servicing. Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
Regeneration Frequency: Replacement frequency will vary with water conditions.
Refer to the Installation and Operation Instructions, Parts List and Printed Warranties for more specific product
information. To avoid contamination from improper handling and installation, your system should only be installed
and serviced by your Culligan Man. Performance will vary based on local water conditions. The substances
reduced by this product are not necessarily in your water.
Buyer Signature _________________________________________________ Date
Seller Signature _________________________________________________ Date
®
10" With Cullar
USEPA SDWA* SMCL Average Test Influent
Concentration Level
N/A
120V/ 60 Hz, 45 Watts
®
Filter
Average Test Effluent
Concentration Level
2.11 mg/L 0.02 mg/L
________________
________________