Advertisement
oven trays when putting liquid preparations in the oven. If you think an overspill is
possible, protect the oven bottom with aluminium foil. Check to see that the bottom of the
oven is clean after each use.
The oven with the self-cleaning feature is the most important improvement in recent years.
Following these recommendations will give you years of satisfactory use.
To assemble the self-cleaning liners, proceed as follows.
Self-cleaning ovens 60 cm series (figs. 1-2-3)
Remove all the accessories from the oven compartment: the horizontal racks, the base
plates, their side supports and the rear deflector unscrewing the relative ring nuts. Now
that the oven compartment is completely bare, the walls can be fitted with the self-
cleaning liners.
For correct assembly proceed as follows:
•
Attach the two side liners to the internal frames of the oven: parts "A" and "B" of
figure 1;
•
Insert the rear liner "C" up against the rear wall, lining it up on the hole "D" or "H"
according to the model. Fix it with either the ring nut "E" or the spring clip "G"
supplied:
•
Slide in the two liners attached to the side frames of the oven compartment fixing
them hooking the points "F" onto the side walls of the oven and the point "I" onto
the rear wall of the oven;
•
Complete the assembly inserting the horizontal racks and the base plates
previously extracted.
Self-cleaning ovens 70 and 90 cm series (figs. 1-4)
Remove all the accessories from the oven compartment: the horizontal racks, the base
plates, their side supports and the rear deflector unscrewing the two relative ring nuts.
Now that the oven compartment is completely bare, the walls can be fitted with the self-
cleaning liners.
For correct assembly proceed as follows:
•
Attach the two side liners to the internal frames of the oven: parts "A" and "B" of
fig. 1;
•
Insert the rear liner "C" (fig. 4) up against the rear wall, fitting the holes "D" on
the fixing boss and screw up the ring nuts "E";
•
Slide in the two liners attached to the side frames of the oven compartment fixing
them hooking the points "F" onto the side walls of the oven and the point "I" onto
the rear wall of the oven;
•
Complete the assembly inserting the horizontal racks and the base plates
previously extracted.
ASSEMBLY INSTRUCTIONS
Advertisement
