Table of Contents
Advertisement
Adtran
Table 1: Recommended Minimum Distance Between the SDG and Household Appliances
Household Appliance
Microwave ovens
Baby monitor – analog
Baby monitor – digital
Cordless phone – analog
Cordless phone – digital
Bluetooth devices
ZigBee
WARNING!
Ensure that the SDG-8610 does not come in contact with water or other liquids.
CAUTION!
Ensure that the SDG-8610 is not located in direct sunlight or next to any thermal obstructions.
Wall Mount Installation
The SDG-8610 can be mounted on a wall. Two #6x1 in. (3.5x25 mm) screws with plastic anchors are required (not
supplied). Install mounting hardware per Manufacturer's directions. The distance between mounting screws is 3 5/32 in.
(80 mm).
Supplying Power to the device
1. Connect the barrel plug of the power adapter to the Power port on the back panel of the SDG.
2. Plug the power adapter into the wall outlet.
3. Turn the power switch to ON. The SDG will begin powering up.
4. Confirm that the power is connected properly. The Multi-function Status LED should be lit on the front of the
gateway.
Subscriber Connections
The following subscriber connections are available on the back of the SDG-8610:
1x 1G Ethernet interface (RJ45 Connector) – LAN port
l
1x 1G Ethernet interface (RJ45 Connector) -WAN-1 port
l
1x SFP cage -WAN-2 port
l
To connect the Ethernet interfaces, refer to
(labeled LAN) and the WAN port (labeled WAN) until there is an audible "click".
If an SFP pluggable is used, insert it in the SFP port. Now connect a fiber-optic cable according to your cabling plan.
6SDG8610-13A
Recommended Minimum Distance (in feet and meters)
30 feet / 9 meters
20 feet / 6 meters
40 feet / 12 meters
20 feet / 6 meters
30 feet / 9 meters
20 feet / 6 meters
20 feet / 6 meters
Features
and insert a Category 5E (or better) RJ45 cable into the LAN port
Supplying Power to the device
3
Advertisement
Table of Contents
