When An Error Message Appears On The Display - Brother P-touch D400 User Manual

When an error message appears on the display

When an error message appears on the display, follow the directions
provided below.
Message
Check # of Digits
Entered!
Cutter Error!
Length Limit!
Text Too High!
Text
Too Long!
System Error XX
The number of digits entered in the barcode data does not
match the number of digits set in the barcode parameters.
Enter the correct number of digits.
The tape cutter has been closed when you tried to print or
feed tape. Turn the P-touch off and then on again before
continuing. When tape is tangled in the cutter, remove the
tape.
The length of the label to be printed using the text entered
is longer than 1 m. Edit the text so that the length of the
label is less than 1 m.
The text size is too large.
The length of the label to be printed using the text entered
is longer than the length setting. Edit the text to fit within
the set length or change the length setting.
Please contact Brother customer service.
TROUBLESHOOTING
Cause/Remedy
When an error message appears on the display
29