(Module D) of the Regulation under surveillance of Notified Body: SGS Fimko Oy (0598) Takomotie 8, FI-00380, HELSINKI, Finland Signed for and on behalf of: Checkmate Lifting & Safety Limited t/a Guardian Fall. Peter Upcott Name: Sheerness, Kent Place:...
Page 3
(Module D) of the Regulation under surveillance of Notified Body: SGS Fimko Oy (0598) Takomotie 8, FI-00380, HELSINKI, Finland Signed for and on behalf of: Checkmate Lifting & Safety Limited t/a Guardian Fall. Peter Upcott Name: Sheerness, Kent Place:...
Risk Statement Worker Classifications CAUTION! Understand following The lanyard is designed to protect against falls definitions of those who will work near or from height and reduce peak forces generated during a fall below 6 kN, when used in accordance who may be exposed to a fall.
Product Specific Applications For All Product Applications WARNING! equipment Anchorage point in PFAS must be rated unintended applications result to withstand minimum 12 kN load and be in serious injury or death. Maximum 1 EN 795:2012 or 1997+A1:2000 approved. attachment per connection point.
Limitations Compatibility Fall Clearance: There must be sufficient When making connections with Shock clearance below the work surface to arrest a Absorbing Lanyard, eliminate all possibility fall before the user strikes the ground or an of roll-out. Roll-out occurs when interference obstruction.
RAL 1.75BB-T Telcomms Shock Absorbing Lanyard w/ring and 2 karabiners Materials Polyester, steel, aluminium The lanyard is recommended for use with the following products. Please contact Guardian with any questions regarding product compatibility. Never extend a lanyard beyond the maximum length stated on the label.
Be any way, immediately remove it from service, and aware that adjusting to longer length will increase contact Guardian to inquire about its return or potential swing fall and free fall.. repair.
Inspection At least every 12 months, a Competent Person other than the user must inspect Shock Prior to EACH use, inspect Shock Absorbing Absorbing Lanyard. Competent Person Lanyard for deficiencies, including, but not inspections MUST be recorded in inspection limited to, corrosion, deformation, pits, burrs, log in instruction manual and on equipment rough surfaces, sharp edges, cracking, rust, inspection grid label.
Safety Information Harnesses and connectors selected must be compliant with manufacturer’s instructions, and WARNING! Failure to understand and must be of compatible size and configuration. comply with safety regulations may result Snap hooks, karabiners, and other connectors in serious injury or death. Regulations must be selected and applied in a compatible included herein are not all-inclusive, are fashion.
Page 11
Compliant with: EN 355:2002 T/A Guardian Fall Competent Person must complete formal inspection every 12 months. New Road, Sheerness, Kent, Part No: 1400126 Product lifetime is 10 years provided equipment passes pre-use and ME12 1PZ United Kingdom Serial No: Competent Person inspections 91662 Rev.
Page 12
Diagram A - Fall Clearance Diagram B - Connections Fall clearance calculation shown below is based on a standing worker falling directly in-line with anchor point. SAMPLE CALCULATION ONLY. ALWAYS REFER CONNECTOR INSTRUCTIONS PRODUCT-SPECIFIC CLEARANCE INFORMATION. ...
Page 16
Checkmate Lifting & Safety +44 (0) 1795 580 333 enquiries@guardianfall.com t/a Guardian Fall New Road, Sheerness guardianfall.com Kent ME12 1Pz, United Kingdom Guardian® and its logo are registered trademarks of Pure Safety Group Inc. dba Guardian Fall in the US and other countries.