Preparing Child Restraint To Fit Your Child - Dorel Juvenile Group Enspira 65 Instruction Manual

C-2 Preparing Child Restraint to Fit
Your Child
You MUST make these adjustments with your child before
you install the child restraint in the vehicle.
1.
Pull UAS Belt Packaging Out
from the Shell
Remove UAS from any
packaging. Discard the
packaging.
2.
Secure UAS
You
to the UAS attachments as
shown when not in use.
3.
Loosen Harness Straps
Push in on the harness
adjustment lever under the flap.
Pull out on harness straps just
above buckle tongues.
4.
Release Chest Clip
Press on chest clip release
button and pull apart.
5.
Unbuckle Harness
Press down on the red buckle
release button to release the
buckle tongues. Place harness
straps over sides of child
restraint.
13
MUST attach the UAS hooks
Adjust Headrest to the
6.
Highest Position
Pull the metal headrest
adjustment bar on the back of
the seat and slide the headrest
all the way up. Release metal
headrest adjustment bar into slot to lock. Make sure metal
headrest adjustment bar is securely locked into place.
This will expose all the upper harness slots.
7. Place Child in Child
Restraint
Place the child's bottom and
back flat against the child
restraint. This will increase
comfort and allow the
harness straps to be properly
tightened.
Check Buckle Position
8.
Determine which of the
three buckle strap slots that
1
is both comfortable and
2
snug to use.
3
NOTE:
through the slot closest to child.
You MUST use the 1st or 2nd buckle strap slots
when rear-facing. Any slot can be used for
forward-facing.
9.
To Change Buckle
Position
Remove child from child
restraint.
Turn the child restraint over
and locate buckle strap's
metal retainer.
14
Thread buckle strap
continued on next page.