Table of Contents
Advertisement
G-4 Install Forward-Facing
With UAS
NOTE: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only
if the belt can be tightened properly and
securely.
Do not fasten both UAS hooks on the same UAS
anchor bar in the vehicle.
When used in the forward facing position, the
child restraint must be used in the upright
position. Vehicle seat back must be upright.
Failure to follow these warnings can result in
serious injury or death.
1.
Place Child Restraint in
Vehicle Forward-Facing
Flush Against Back Seat
When used in the forward facing
position, the child restraint
MUST be used in the upright
position. To pull recline stand
out, see section C-6.
NOTE: Do not use the level to ground lines on the side of the
child restraint in the forward-facing position.
51
Installation Tip:
Loosely attach the
tether hook before
attaching the
UAS belt. Consult
vehicle's owner
manual for specific
location.
2.
Connect UAS to Vehicle
UAS Anchor Bar
Fasten one UAS hook to
the UAS anchor bar in the
vehicle seat bight. Repeat
for other side of child
restraint.
3.
Tighten UAS Belt
Place knee in the child
restraint. Push down firmly
while pulling up on the
free end of the UAS belt to
tighten.
It may be easier to tighten
the belt through the belt path
opening as shown.
4.
Tighten the Tether Strap
With knee still in child restraint,
push down on the child restraint
again and pull on free end of the
tether strap to tighten.
52
continued on next page.
Advertisement
Table of Contents
