Conductivity; Operating Hours; Factory Default - Miele TWV 780 WP Operating Instructions Manual

-
Off
This reminder does not appear. How-
ever, if there is a very severe blockage
in the ducting, the programme will be
cancelled and the fault message

Clean the fluff filter. Check the airways.
will appear in the display regardless of
this option.
-
Heavy
The reminder only appears when there
is a heavy build-up of fluff.
-

(factory default)

Normal
-
Light
The reminder appears when there is
only a small build-up of fluff.

Conductivity

This setting is only relevant for regions
with very soft water.
Very soft water can result in unsatis-
factory drying results.
You should only select this setting if
the water used for washing the laun-
dry is extremely soft with a conduct-
ivity reading (electrical conductivity)
less than 150 μS/cm. Contact your
local water authority for the conduct-
ivity level of your mains water supply.
Options
- (factory default)
Normal
- (only for regions with very
Low <150mS
soft water)

Operating hours

You can read off how many hours your
tumble dryer has been in operation for.
The time is displayed as the total run-
ning time in hours.
Factory default
All settings except Operating hours are
reset to the factory default settings.
Options

Reset to factory settings?
- Yes
The settings are reset to the factory
default settings.
- No
The settings are not reset to the fact-
ory default settings.
Settings
97