Temperature Indicator - Smeg FA100AP Instruction Booklet

Temperature indicator

In order to help you better set your refrigerator, we have
equipped it with a temperature indicator located in the cold-
est area.
To better store the food in your refrigerator, especially in
the coldest area, make sure the message "OK" appears
on the temperature indicator. If « OK » does not appear,
this means that the temperature setting has not been done
properly.
Since "OK" appears in black, it will be difficult to see this indication if the temperature
indicator is badly lit. To be able to see this indication properly, there should be enough
light.
Each time the temperature setting device is changed, wait for the stabilisation of the
temperature inside the appliance before proceeding, if necessary, with a new tempera-
ture setting. Please change the position of the temperature setting device progressively
and wait at least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting
fresh food into the appliance, it is normal for the indication "OK" not to appear in the
temperature setting indicator. If there is an abnormal ice crystals build up (bottom wall of
the appliance) on the refrigerator compartment evaporator (overloaded appliance, high
room temperature, frequent door openings), put the temperature setting device on a
lower position until compressor off periods are obtained again.
Putting food in the coldest area of the refrigerator
Your foods will be better stored if you put them in the most
appropriate cooling area. The coldest area is just above the
crisper.
The following symbol indicates the coldest area of your refrig-
erator.
To be sure to have a low temperature in this area, make sure
the shelf is located at the level of this symbol, as shown in the
illustration.
UK - 7 -