Advertisement
RADH Electric Radiant Heaters
NOTE: Please familiarize yourself with these instruc-
tions before attempting to install or connect this Radi-
ant Heater.
FIRE HAZARD. Radiant heaters are capable of
developing high temperatures, care should be
taken to:
A. Mount heater with the proper clearance
from adjacent surfaces.
B. Do not mount heater over combustible sur-
faces.
Installation
The system designer is responsible for the
safety of this equipment and should install ad-
equate back-up controls and safety devices
with their electric heating equipment. Where
the consequences of failure could result in per-
sonal injury or property damage, back-up con-
trols are essential.
Before Installing
1. Open carton and remove heater at the place of instal-
lation. Mounting clamps are in parts bag in carton.
2. Check nameplate volt and watt rating against your
power supply voltage and heating requirements of
your installation. This nameplate of the complete as-
sembly is located on the back of the heater housing.
C. Do not stack or store combustible materi-
als directly below the heater or in the space a
distance of 5 feet from any projected edge of
the heater.
D. Do not operate the heater without Ground
Fault Equipment Protection.
Failure to follow these instructions can result
in personal injury and fire.
Figure 1 — Heater Parts & Dimensions
2
Advertisement
