O. Exceeding the maximum static load will result in the tripping of the overtemperature control. The per- formance range of the SDRA units is as shown in table B. The motor and fan have variable pitch pulleys for changing the air flow and the ΔT.
Page 3
AD-16 WIRING (cont’d.) SDRA heaters can be easily field if modified to vary the fan speed. There may be some circumstances where the use of short lengths of duct may not create sufficient pressure drop to achieve the desired tem- perature rise.
Page 4
3. Remove the rear grille by removing the (4) 1/4” bolts and nuts. 4. Remove the belt cover inside the blower by removing the (4) sheet metal screws. 5. Loosen the (4) bolts, (2) on each side. See Fig. 1.
1/4" Conduit Heater Terminal Box One end attached to screw in terminal box and other end attached to screw on sub panel. Front of Heater SDRA 30kW, 480V, 3PH Cutout Front Heater SDRA 48kW, 480V, 3PH Cutout Front Heater...
Element Assembly 30kW Front of Heater View Showing Element Placement and Routing of Thermostat Capillary Element Assembly 60kW Fan Pulley Back of Heater Motor Pulley Side View Detail Showing Pulley and Belt Installation Side View shown with Heater and Control Terminal Box Covers Removed PARTS LOCATION Front of Heater...
Element (11) Model No. Volts kW Phase Part No. SDRA-30-43 118-304793-011(3) 118-304793-013(3) 193-121843-232 072-304551-008 SDRA-30-93 118-304793-012(3) 118-304793-014(3) 193-121843-233 072-304551-008 SDRA-48-43 118-304793-011(3) 118-304793-013(6) 193-121843-232 072-304551-008(2) 315-304252-001 129-025643-001...
Page 8
Limited Warranty: Please refer to the Chromalox limited warranty applicable to this product at http://www.chromalox.com/customer-service/policies/termsofsale.aspx. 2150 N. RULON WHITE BLVD., OGDEN, UT 84404 Phone: 1-800-368-2493 www.chromalox.com...