Start/Pause - Electrolux 6 Series Service Manual

4.1.6 Start/pause

When a programme is selected and the appliance door is closed, simply press the Start/Pause button to start
the cycle.
The corresponding LED will stop flashing and will remain lit permanently, while the display is
consequently updated.
Should the door not be closed, the display will not show the time left until the end of the cycle but error "Err"
and the LED will flash.
After removing the error by closing the door, press Start/Pause again for the cycle to start up again.
Press the Start/Pause button during the cycle to pause the appliance.
When the appliance is on pause, you can add or remove options, but you cannot change the programmes; to
do this, in this case, you need to turn off the tumble dryer at the On/Off button, or reset the programme by
turning the programme selector dial to the central position .
Technical Support - A.D.L. 15/76 599 74 12-74 Rev.01