Safety And Installation; Safety Measures - Electrolux 6 Series Service Manual

1 Safety and Installation

1.1 Safety measures


Before starting work on a piece of equipment, check that the earth in the lodgings is working
properly by using an appropriate tool and follow the instructions described/illustrated on the
Electrolux Learning Gateway portal

http://electrolux.edvantage.net

When the work is finished check that the equipment's safety conditions have been reinstated,
as though it were straight off the assembly line.

In the event of handling/replacing the electronic circuit board, use the ESD (Cod. 405 50 63-95/4) kit
to avoid electrostatic discharges damaging the electronic circuit board see S.B. Nr. 599 72 08-09.

All the work to be performed inside the appliance requires specific skills and knowledge and may
only be carried out by qualified and authorised service engineers.

Some of the components in the mechanical part could cause injuries, so wear suitable protection
and proceed with caution.

This platform is not fitted with an On/Off switch. Before you access internal
components, take the plug out of the socket to disconnect the power supply.

Always empty all the water from the condensation tank before laying the appliance on its side.

If the appliance has to be placed on its side for maintenance or
another reason, lie it on its left side, to avoid the risk of any
residual water falling onto the main circuit board.

When replacing components, please refer to the code shown in the list of spare parts relating to
the appliance.
Technical Support - A.D.L. 5/76 599 74 12-74 Rev.01