Table of Contents
Advertisement
USING THE PROJECTOR
System Status
The current status of the projector is displayed.You can check projector model name, firmware version,
current LAN configuration, and change the interface language if needed.
The version name displayed on the web page in the diagram may differ from the actual display.
General Setup
The projector name set here is also used in PJLink control.Only alphanumeric characters can be used
as projector name. The maximum number of characters is 32.
You can use only alphanumeric characters in the password. The minimum number of characters is 8. If
you enter an invalid character, "Invalid Character" warning is displayed.
If the characters of new password and the characters of confirm (new) password do not match, error
message will be displayed. In this case, re-enter the password.
49
English
Advertisement
Table of Contents
